Comtech EF Data SLM-5650A Installation And Operation Manual page 226

Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
CnC-APC State
(cont)
Buffer Fill State N/A BFS?
Clear All Stored CAE= N/A
Events
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
11 = OK(Partial) – Distant power approaches limit set by max
power level increase
12 = OK(Partial) – Incomplete
13 = No APC Frame Sync
14 = CnC Ratio Problem
15 = Local Eb/No too high
16 = Distant Eb/No too high
17 = Distant End ReBalance failed
18 = Distant End No Response
19 = Fail-Calculate Mismatch
20 = CnC Ratio too high
21 = Please run again
22 = APC is active
23 = Local margin too low
24 = Distant margin too low
25 = Rx Data Rate < 64 kbps
26 = Tx Data Rate < 64 kbps
27 = Local RSL too low
28 = Distant RSL too low
29 = Unrecognized Modem
Example: >0001/APS=00{CR}{LF}
2 bytes Query only.
Returns the value of the buffer fill state in the form xx, where:
xx = value from 1 to 99%
Note: Returns 00 if demodulator is unlocked.
Example: >0001/BFS=33{CR}{LF} (reports 33%)
None Command only.
Forces the firmware to clear the Stored Events log.
Note: This command takes no arguments.
Description of Arguments
10–32
SLM-5650A Satellite Modem
Revision 10
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
N/A BFS=xx
CAE= N/A
CAE?
CAE*
CAE#
MN-SLM-5650A