Service Program Mode Operation - Ricoh FT6645 Manual

SERVICE PROGRAM MODE
2. SERVICE PROGRAM MODE

2.1 SERVICE PROGRAM MODE OPERATION

The service program (SP) mode is used to check electrical data, change
modes, and adjust values.
2.1.1 Service Program Access Procedure
1. Press the clear modes key.
2. Enter "107".
3. Press the clear/stop key for more than 3 seconds until the service
program menu appears on the touch panel display.
4. Touch a number [A] on the
display to access the desired
function.
This copier has 9 service
program modes
(mode is not used).
5
Only 5 service program modes
are visible on the touch panel
display at one time.
Use the down key [B] or the up
key [C] to see other service
program mode menus.
2.1.2 To Exit SP Mode
Quit
1. Touch the
1
[A]
key [D].
0
4-6
23 April 1993
7
C
[D]
[C]
[B]