Replacing Pickup Hp Motor - Konica Minolta drypro 832 Service Manual

Chapter 4 Replacing Supply Unit Loading Parts

4.2.4 Replacing Pickup HP Motor

Replace the drive motor that saves the pickup roller.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing load parts.
Caution
Work outline
The number of personnel and the estimated work hours required to replace load parts is as follows:
Number of
Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3 Pickup HP motor (for replacement)
4-18
Work Hours
5 minutes
Tools
1
2
3
4
No. Tools
2 Tray (container for screws and parts removed)
Remove the supply tray, lower front cover,
connector (JJ48), light shield unit assembly and
pickup unit assembly with reference to
Removal Procedure (Page 4-11)"
Removing/Installing Pickup Unit
When replacing loading parts, be sure to
replace with the tray shutter attached.
Caution
If some of film remains in the tray, the film
may be exposed.
Remove the bracket.
• Two screws (M3×6)
Disconnect the wire from the wire saddles.
• Wire saddle in one location
Remove the relay connector (JP54).
When removing the connector, do not pull by
the wires, but hold the tab on the connector
Caution
with your fingers.
Pulling by the wires too tightly can cause a
break.
"
in "4.2.2
Assembly".