Konica Minolta drypro 832 Service Manual page 90

Laser imager
Hide thumbs Also See for drypro 832:
Table of Contents

Advertisement

Chapter 5 Replacing Tray Unit Loading Parts
To replace the tray unit tray detection sensor, proceed to
To replace the Lispl-832 tray detection sensor, proceed to
Note
5-16
3
Remove the rear cover.
• Six screws (M4×8)
Remove the upper two screws and the one screw
in the center from the rear cover and loosen the
Note
bottom three.
Proceed to
step
5.
4
Remove the rear cover of Lispl-832.
・ Six screws (M4×8)
5
Remove the connector.
To replace the tray unit tray detection sensor, remove the
connector (JP56).
To replace the Lispl-832 tray detection sensor, remove the
connector (JP64).
When removing the connector, do not pull by
the wires, but hold the tab on the connector
Caution
with your fingers.
Pulling by the wires too tightly can cause a
break.
6
Remove the supply elevating motor holding
bracket together with the motor.
• One screw (M3×6)
The bracket is hooked on the notch in the main
unit, but can be unhooked by sliding slightly to the
right and pulling back.
step
7.
step
9.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents