Konica Minolta drypro 832 Service Manual page 466

Chapter 17 Troubleshooting
Exit the application
(Only for CS-2 and CS-3)
Checking the image
quality
Backing up setup
END
17-78
•
Check that the serial number of DRYPRO 832 ① is same as the Serial
Number of the backup file ② in following setup restore window.
Caution
Check the serial number of the device on the label if ① and ② is different.
If the serial number on the label is different from ① , there is a chance that
there was a mistake in unit selection in previous "Selecting Replaced Unit".
Refer to " When Mistake was Made Selecting Replaced Unit (Page 17-
79)", and recover the previous status.
If the serial number on the label is same with ① , there is a chance that
there was a mistake in selection of the backup. Select the backup file with
same serial number as above ① .
If there is no backup file, DRYPRO 832 needs to be replaced.
For details, refer to "17.3.3 Replacing the DRYPRO 832 (Page
Refer to "7.4 How to Exit CS-2 and CS-3" in the installation manual
Refer to "5.4 Checking Image Quality",
Pattern Base" in the installation manual, and check the image quality.
If the settings cannot be restored by restoration of V1.02 or later,
perform "5.5.3 Built-in Densitometer Calibration" in the installation
Caution
manual.
Refer to "Chapter 6: Backing up Setup" in the installation manual
DRYPRO 832 using the MainteTool.
to exit CS-2 or CS-3.
"5.5 Checking Density Linearity", and
to backup the setup data of
17-82)".
"5.6 Creating QC