Konica Minolta drypro 832 Service Manual page 227

11
Connect the connector (JP24) removed in
Be sure to push the connector all the way in when connecting it.
If the connector is not connected properly, an error will occur and, in some cases, smoke and/or
Caution
an odor may be generated.
12
Connect the connectors removed in
supply (JP52).
Be sure to push the connector all the way in when connecting it.
If the connector is not connected properly, an error will occur and, in some cases, smoke and/or
Caution
an odor may be generated.
13
Install the rear cover with reference to
Removing/Installing Rear
14
Install the connector cover removed in
15
Install the LAN cover and film ejection tray with reference to
3-11)" in "3.3.2 Removing/Installing Film Ejection
This is the end of the process of replacing the control cooling fan.
Chapter 11 Replacing Loading Parts in Main Unit
step 4.
step 3 to MEC IF (CCN5), exposure IF (CCN6), and power
" Installation Procedure (Page 3-19)"
Cover".
step 2.
Tray".
in "3.3.4
" Installation Procedure (Page
11-27