Konica Minolta drypro 832 Service Manual page 456

Chapter 17 Troubleshooting
Setting up Network
17-68
4. Set the [Use the following IP address] radio button to ON and enter the factory
setting IP address and subnet mask.
5. Click the [OK] button and then the [Close] button.
Setup the network.
However, the network setup procedure differs depending on the server PC (Printlink5-IN or CS2
and CS-3).
When the server PC is CS-2 or CS-3
1. Startup the CS-2 or CS-3.
After starting up WindowsXP, a dialog box is displayed.
2. Check that the factory IP address (192.168.20.161) is entered in the [IP
ADDRESS] entry field, and click the [SERVICE] button.
"Enter Password" dialog box is displayed.
3. Enter "5678" in the [Password] entry field, and click the [OK] button.
The main window of the DRYPRO 832 Utility Tool is displayed.
License registration is required for the oversea version.