Replacing Transfer Belt - Konica Minolta drypro 832 Service Manual

7.8

Replacing Transfer belt

Replace the Transfer belt that transfers drive of the inlet roller to the outlet roller.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing loading parts.
Caution
Work outline
The number of personnel and the estimated work hours required to replace loading parts is as follows:
Number of
Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3 Steel belt (for replacement)
Chapter 7 Replacing Sub Scan Unit Loading Parts
Work Hours
10 minutes
Tools No.
2
4
1
Remove the sub scan unit with reference to
"
Removing/Installing Sub Scan Unit (Including the
Exposure Unit and Position Regulation
2
Remove the cover.
• Two screws (M3×6)
Tools
Tray (container for screws and parts removed)
Gloves
Removal Procedure (Page 7-4)"
•
When replacing loading parts, be sure to
replace with the tray shutter attached. If
Caution
some of the film remains on the tray, the
film may be exposed.
•
When pulling out the sub scan unit, be
careful not to get it hung up on a wire.
•
The sub scan unit weighs approximately
16kg.
Carefully perform work when unloading the
sub scan unit from the main unit or
transporting it to work site.
•
If you place the removed sub scan unit on a
table, it may become extremely unstable. It
should be kept in mind that applying
excessive pressure could overturn the unit.
in "7.2
Unit)".
7-25