Konica Minolta drypro 832 Service Manual page 115

Chapter 6 Replacing Lispl-832 (Optional) Loading Parts
4
Remove the E ring with a precision screwdriver.
・ One E ring
When removing the E ring, be sure not to
exert too much force. Doing so may cause
Caution
you to stab your finger with the precision
screwdriver, or may cause the E ring to
spring out and become lost.
5
Remove the polyslider.
・ One polyslider
6
Remove the E ring with a precision screwdriver.
・ One E ring
When removing the E ring, be sure not to
exert too much force. Doing so may cause
Caution
you to stab your finger with the precision
screwdriver, or may cause the E ring to
spring out and become lost.
7
Remove the gear.
・ One gear
8
Remove the side plate.
・ Three screws (M3×6)
9
Take out the shaft.
10
Remove the guide.
• Four screws (M3×6)
6-19