Konica Minolta drypro 832 Service Manual page 112

Chapter 6 Replacing Lispl-832 (Optional) Loading Parts
10
Install the bracket removed in
• Two screws (M3×6)
11
Install the two gears removed in
12
Install the E ring removed in
When attaching gears, attention should be paid to the gear orientation.
After assembly, move the peripheral gears by hand and confirm that the assembled gear
Caution
moves in conjunction.
13
Connect the connector (JP80) removed in
Be sure to push the connector all the way in when connecting it.
If the connector is not connected properly, an error will occur and, in some cases, smoke and/or
Caution
an odor may be generated.
6-16
7
Remove the bracket.
• One screw (M3×6)
The bracket shaped like a hook is inserted into the main
body. While sliding the bracket slightly, pull it out.
8
Push the tab on the back of the sensor inward
and remove the photo sensor.
9
Insert a new photo sensor in the mounting hole.
step 6.
step 5.
step 4.
step 2.
14
Install the bracket removed in
• One screw (M3×6)
Hook the notch of the bracket onto the notch of the main unit
and attach it after determining the attachment position with
emboss at two places.
step 7.