Check the current
Start the DRYPRO 832 unit, and if you can check the settings from the Printlink5-IN, check the following
settings
items from the DRYPRO 832 Utility Tool Maintenance menu window and make a note of them.
•
Film setup
•
MAINTENANCE SCHEDULE
•
Product Setup
Caution
Exit the DRYPRO 832
Refer to
unit
Power source breaker OFF
Replace the compact
Refer to
flash
Upgrading server PC
Upgrade the server PC version to a later version than [V1.01R00].
However, the upgrade procedure differs depending on the server PC (Printlink5-IN or CS-2 and
CS-3).
When the server PC is CS-2 or CS-3
1. Before upgrading the software, click the [Help] tab on the "Prinlink5 Maintenance
Main Window" and check the current version.
•
Number of sheets of film remaining in the tray
•
MAINTENANCE SCHEDULE (ELAPSED TIME, PRINTED SHEETS)
•
SIZE FINE TUNING (H, V, requested size)
•
Non-uniform Lens Correction
If the Lispl-832 is connected, setup in the same way and make a note of the
settings.
"3.2.1 How to Exit" in the operation manual
"11.4 Replacing Compact Flash (Page 11-11)"
Chapter 17 Troubleshooting
to exit the DRYPRO 832 and switch the
to replace the compact flash.
17-65