Konica Minolta drypro 832 Service Manual page 198

Chapter 10 Replacing Ejection Unit
10-4
4
Remove the rear cover.
• Six screws (M4×8)
Remove the upper two screws and the one screw
in the center from the rear cover and loosen the
Note
bottom three screws.
5
Remove the left cover.
• Four screws (M4×8)
Slide the left cover upward so that the tabs (two locations)
on the inside of the left cover detach from the main unit, and
remove the cover.
Remove the two screws on the upper part of the
left cover and loosen two screws on the lower
Note
part.
6
Disconnect the connector (OCN1) connected to
the operation panel.
When removing the connector, do not pull by the
wires, but hold the tab on the connector with your
Caution
fingers.
Pulling by the wires too tightly can cause a break.
To make it easy to disconnect the connector,
remove wire from the clamps and wire saddle.
Note
7
Remove the exterior of the operation panel.
• Two screws (M4×8)
8
Remove the relay connector (JJ27).
When removing the connector, do not pull by
the wires, but hold the tab on the connector
Caution
with your fingers.
Pulling by the wires too tightly can cause it
to break.