Konica Minolta drypro 832 Service Manual page 85

•
To replace the tray unit tray lock solenoid, proceed to
•
To replace the Lispl-832 tray lock solenoid, proceed to
Note
Chapter 5 Replacing Tray Unit Loading Parts
3
Remove the rear cover.
• Six screws (M4×8)
Remove the upper two screws and the one screw
in the center from the rear cover and loosen the
Note
bottom three.
Proceed to step 5.
4
Remove the rear cover of Lispl-832.
・ Six screws (M4×8)
5
Remove the connector.
•
To replace the tray unit tray lock solenoid, remove the
connector (JP56).
•
To replace the Lispl-832 tray lock solenoid, remove the
connector (JP64).
When removing the connector, do not pull by
the wires, but hold the tab on the connector
Caution
with your fingers.
Pulling by the wires too tightly can cause a
break.
6
Remove the supply elevating motor holding
bracket together with the motor.
• One screw (M3×6)
The bracket is hooked on the notch in the main unit, but can
be unhooked by sliding slightly to the right and pulling back.
step 7.
step 9.
5-11