Product Setup - Konica Minolta drypro 832 Service Manual

15.17 Product Setup

The constants can be checked or changed to control each hardware.
Each constant for product setup is set to an optimum value at the factory. Do not change unless
otherwise instructed.
Caution
1
Refer to "15.1 DRYPRO 832 Utility Tool Start (Page
window of the DRYPRO 832 Utility Tool.
2
Click the [PRODUCT SETUP] button under "SERVICE INFO".
The "PRODUCT SETUP" window appears.
"PRODUCT SETUP" window
1
2
3
4
5
6
7
8
10
The "PRODUCT SETUP" window contains the following items.
No. Setup Items
1 SERIAL NO.
2 SIZE FINE
TUNING(Horizontal)
3 SIZE FINE
TUNING (Vertical)
4 SIZE FINE TUNING
(REQ. IMG)
5 HD OFFSET
6 VD OFFSET
Description of Settings
Displays the serial number of each DRYPRO 832.
Set the adjusted value of the image size in the H direction.
Setting range: 9900-10100
Set the adjusted value of the image size in the V direction.
Setting range: 9000-11000
Set when the accuracy using an input device to specify the requested image size
(Requested image size specification) results is insufficient.
Setting range: 9500 to 10500
Ex.) Even though the horizontal size was specified as 300 mm using an input
device, the imager outputs an image with a horizontal size of 303 mm.
•
Set "SIZE FINE TUNING (REQ. IMG)" to 99% (setting: "9900").
Set the adjusted value of Main Scan OFFSET image writing position.
Setting range: 1000-1700
Set the adjusted value of Sub Scan OFFSET image writing position.
Setting range: 200-800
Chapter 15 DRYPRO 832 Utility Tool
15-2)", and open the maintenance menu
9
11
15-37