Konica Minolta drypro 832 Service Manual page 484

Chapter 17 Troubleshooting
Start the server PC
Install the Printlink Build IN
(CS-2 and CS-3 only)
Upgrading server PC
(Printlink5-IN only)
Restore the setup
Restart the server PC
Exit the application
(CS-2 and CS-3 only)
Start the DRYPRO 832
17-96
If the power for the server PC is OFF, turn the power ON.
Connection error message is displayed when the server PC is CS-2 or CS-3.
Click the [Yes] button, and close the dialog box.
Caution
Refer to "Chapter 7: Connecting and Setting CS-2 or CS-3" in the installation manual
the latest Printlink Build IN.
However, select "BuiltIN" in the "Mode select" window at installation.
Refer to "16.4 Upgrade Information (Page
a newer version than [V1.01R00].
Only when the server PC is Printlink5-IN
Refer to "16.6 Restoring Settings (Page 16-26)"
Perform the restore for the Printlink5-IN. Do not restore DRYPRO 832.
If you have restored DRYPRO 832, it will be set to setting from the previous
backup. Change the setting to the one with the changes made after previous
Caution
backup.
Restart the server PC (Printlink5-IN, CS-2, or CS-3)
Refer to "7.4 How to Exit CS-2 and CS-3" in the installation manual
Refer to "3.1.1 How to Start" in the operation
starts normally.
However, if the MEC upgrade is performed at startup, the startup time may take a few
minutes longer than normal.
Note
16-12)", and upgrade the Printlink5 software to
to restore the setup.
to exit CS-2 or CS-3.
manual, and check whether the DRYPRO 832
to install