Konica Minolta drypro 832 Service Manual page 241

10
Install the switch cover removed in
11
Connect the connector (PSCN1) removed in
Be sure to push the connector all the way in when connecting it.
If the connector is not connected properly, an error will occur and, in some cases, smoke and/or
Caution
an odor may be generated.
12
Install the switch mounting plate removed in
• Two screws (M3×6)
13
Install the left cover with reference to
Removing/Installing Left
14
Install the ejection unit cover removed in
• Two screws (M4×8)
15
Connect the relay connector (JJ27) removed in
Be sure to push the connector all the way in when connecting it.
If the connector is not connected properly, an error will occur and, in some cases, smoke and/or
Caution
an odor may be generated.
16
Install the exterior of the operation panel with reference to
12-5)" in "12.2 Removing/Installing Exterior of Operation
17
Return the supply tray and tray shutter to their original positions.
Take sufficient care when handling the tray shutter, as it may be impossible to insert if it
becomes deformed due to rough handling.
Caution
This is the end of the process of replacing the operation switch board.
Chapter 12 Replacing Loading Parts in the Exterior of Main Unit
step 7.
step 6.
step 6.
" Installation Procedure (Page 3-23)"
Cover".
step 4.
step
in
2.
" Installation Procedure (Page
Panel".
"3.3.6
12-13