Table of Contents
Advertisement
2. PERIODIC CHECK
2.1.2
Replacing the punch scraps conveyance motor (M7)
A. Periodically replaced parts/cycle
•
Punch scraps conveyance motor (M7): Every 3,000,000 prints (every 1,000,000 punches for actual
replacement cycle)
B. Procedure
[4]
[3]
[2]
[1]
[3]
6
[1]
15kvf2c003na
[2]
[4]
15kvf2c004na
Field Service Ver1.0 Jun.2005
1. Remove ZU from the main body (See "3.3.2
Removing/reinstalling ZU from the main body.")
2. Disconnect the connector [1].
3. Remove 2 screws [2], and then remove the punch
scraps conveyance motor unit [3].
Note
• When reinstalling the punch scraps convey-
ance motor unit [3], be sure to check the
worm gear [4] rotates smoothly and there is
appropriate backlash.
4. Remove 2 screws [1], and then remove the punch
scraps conveyance motor (M7) [3] from the
mounting plate [2].
Note
• When reinstalling M7 [3], apply grease (Plas
Guard No. 2) to the worm gear [4].
5. Reinstall the above parts following the removal
steps in reverse.
Advertisement
Chapters
Table of Contents
