Replacing Control Cooling Fan - Konica Minolta drypro 832 Service Manual

11.9 Replacing Control Cooling Fan

Replace the fan unit that cools the control unit.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing loading parts.
Caution
Work outline
The number of personnel and the estimated work hours required to replace loading parts is as follows:
Number of Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools
No.
1 Various types of screwdrivers
3 Fan unit (for replacement)
Chapter 11 Replacing Loading Parts in Main Unit
Work Hours
10 minutes
Tools No.
2
1
Remove the LAN cover and film ejection tray with
reference to
10)" in
Tray".
2
Remove the connector cover.
3
Remove connectors from MEC IF (CCN5),
exposure IF (CCN6), and power supply (JP52).
Caution
Tools
Tray (container for screws and parts removed)
" Removal Procedure (Page 3-
"3.3.2 Removing/Installing Film Ejection
When removing the connector, do not pull by
the wires, but hold the tab on the connector
with your fingers.
Pulling by the wires too tightly can cause a
break.
11-25