Konica Minolta drypro 832 Service Manual page 232

Chapter 12 Replacing Loading Parts in the Exterior of Main Unit
This is the end of the process of removing the exterior of the operation panel.
•
When replacing the LCD board, go to
•
When replacing the status lamp, go to
•
When replacing the operation switch board, go to
12-4
4
Disconnect the connector (OCN1) connected to
the operation panel.
When removing the connector, do not pull by
the wires, but hold the tab on the connector
Caution
with your fingers.
Pulling by the wires too tightly can cause a
break.
To make it easy to disconnect the connector,
remove wire from the clamps and wire saddle.
Note
5
Remove the exterior of the operation panel.
• Two screws (M4×8)
"12.3 Replacing LCD Board (Page
"12.4 Replacing Status Lamp (Page
"12.5 Replacing Operation Switch Board (Page
12-6)".
12-8)".
12-11)".