Konica Minolta drypro 832 Service Manual page 414

Chapter 17 Troubleshooting
Error
Error Error
Message (Display
Level Code
Characters)
F 8010 Application
error
F 8080 Application
error
F 8081 Application
error
F 8082 Application
error
F 8083 Application
error
F 8084 Application
error
F
8090 Application
error
F 8091 Application
error
F 8092 Application
error
F 8093 Application
error
F 80A0 Application
error
F
80A1 Application
error
F 80A2 Application
error
F 8100 Application
error
F 8101 Application
error
F 8102 Application
error
F 8104 Application
error
F
8105 Application
error
F 8200 Print control
error
17-26
Error contents
Cannot receive 1A from mechanical
control.
Retry of print server update is over
Cannot open retry file.
Cannot write into retry file.
Cannot close retry file.
Cannot delete retry file.
Error updating the print version, or there
is no file.
Cannot open print version update file.
Cannot write print update file to FLASH-
ROM.
Cannot read print version update file.
Print driver device error
Print driver device open error
No pixel clock output
Flash ROM delete error
Flash ROM comparison error
Memory error
Reception error
Received data error
Driver: Device not registered
Error Support: Service
1. Check for disconnected connectors of
communication cable between main ? mechanical
control (control board side, mechanical control side)
2. Check communication cable between main ?
mechanical control for broken wires
3. Replace cables between main mechanical control
4. Replace the mechanical control board
5. After replacing the control box, restore the settings
After replacing the control box, restore the settings
Replace the main board
Replace the mechanical control board
After replacing the control box, restore the settings
1. Check for disconnected connectors of
communication cable between main-mechanical
control (control board side, mechanical control side)
2. Check communication cable between main-
mechanical control for broken wires
3. Replace cables between main-mechanical control
4. Replace the mechanical control board
5. After replacing the control box, restore the settings
The cause of this error is either software or hardware.
Either reset the error, or switch the power OFF/ON.
If this does not correct the problem, either upgrade the
software or replace the control box.