14
Connect the connector removed in
•
If the tray unit elevating plate HP sensor has been replaced, connect the connector (JP56).
•
If the Lispl-832 elevating plate HP sensor has been replaced, connect the connector (JP64).
Be sure to push the connector all the way in when connecting it.
If the connector is not connected properly, an error will occur and, in some cases, smoke and/or
Caution
an odor may be generated.
15
Install the rear cover or the back cover.
•
If the tray unit elevating plate HP sensor has been replaced, refer to
in
"3.3.4 Removing/Installing Rear Cover"
•
If the Lispl-832 elevating plate HP sensor has been replaced, refer to
in
"3.3.5 Removing/Installing Rear Cover (Lispl-832)"
16
Return the supply tray and tray shutter to their original positions.
Take sufficient care when handling the tray shutter, as it may be impossible to insert if it
becomes deformed due to rough handling.
Caution
This is the end of the process of replacing the elevating plate HP sensor.
Chapter 5 Replacing Tray Unit Loading Parts
step
5.
"
and then attach the rear cover.
"
and then attach the back cover.
Installation Procedure (Page 3-19)"
Installation Procedure (Page 3-21)"
5-9