9
Install the bracket removed in
• One screw (M3×6)
Fix so that the positioning hole in the bracket aligns with the emboss on the mating part.
10
Connect the connector (JP10) removed in
Be sure to push the connector all the way in when connecting it.
If the connector is not connected properly, an error will occur and, in some cases, smoke and/or
Caution
an odor may be generated.
Chapter 7 Replacing Sub Scan Unit Loading Parts
4
Open the external guide unit assembly by rotating
the lever B in the direction of an arrow.
5
Remove the cover.
• Two screws (M3×6)
6
Remove the bracket.
• One screw (M3×6)
7
Push the tab on the back of the sensor inward
and remove the photo sensor.
8
Insert a new photo sensor in the mounting hole.
step
6.
step
2.
7-13