Konica Minolta drypro 832 Service Manual page 106

Chapter 6 Replacing Lispl-832 (Optional) Loading Parts
6-10
4
Remove the right cover and lower right with
reference to "3.3.1 Removing/Installing Lower
Right Cover (Page 3-6)".
5
Remove the screws from the right cover.
• Four screws (M4×8)
6
Insert the long screwdriver through the access
hole and unlock the right cover.
7
Open the right cover and remove the connector
(JJ81).
When removing the connector, hold the tab
on the connector with your fingers and
Caution
disconnect it.
Pulling by the wires too tightly can cause a
break.
8
Remove the elevating transport unit.
Remove the elevating transport unit shaft on the
the shaft on the side shown in the figure to the left, from
the notch of the main unit frame.
•
Either the shaft on the
may be removed first.
Note
•
If the shaft is difficult to remove from the
notch in the frame, stand the elevating
transport unit as vertical as possible and the
shaft will be easier to remove.
side and
side or the side