Removing/Installing Film Ejection Tray - Konica Minolta drypro 832 Service Manual

Chapter 3 Basic Operations
3.3.2

Removing/Installing Film Ejection Tray

This section describes how to remove/install the film ejection tray.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing loading parts.
Caution
Removal Procedure
This is the end of the process of removing the film ejection tray.
3-10
1
Remove the LAN cover.
2
Remove the LAN cable from the connector cover
slots.
3
Disconnect the LAN cable.
4
Remove the film ejection tray.
• Two screws (M4×8)