Chapter 11 Replacing Loading Parts in Main Unit
9
Install the control box assembly removed in
• Four screws (M3×6)
10
Install the control board duct unit assembly removed in
• Three screws (M3×6)
11-26
4
Remove the connector (JP24) from the control
box DC fan.
When removing the connector, do not pull by
the wires, but hold the tab on the connector
Caution
with your fingers.
Pulling by the wires too tightly can cause a
break.
5
Remove the control board duct unit assembly.
• Three screws (M3×6)
6
Remove the control box assembly.
• Four screws (M3×6)
Loosen the screws and remove the control unit by sliding it
slightly.
7
Remove the control cooling fan.
• Four screws (M3×35)
8
Install a new control cooling fan.
• Four screws (M3×35)
step
6.
step
5.