Chapter 7 Replacing Sub Scan Unit Loading Parts
3
Remove the connector (JP10).
When removing the connector, do not pull by
the wires, but hold the tab on the connector
Caution
with your fingers.
Pulling by the wires too tightly can cause it
to break.
4
Remove the exposure unit mounting frame unit
assembly.
• Four screws (M4×6)
5
Place the sub scan unit upside down and remove
the steel plate.
• Four screws (M3×6)
6
Remove the connector (JJ51).
When removing the connector, do not pull by
the wires, but hold the tab on the connector
Caution
with your fingers.
Pulling by the wires too tightly can cause a
break.
7
Remove the connector (JP34).
When removing the connector, do not pull by
the wires, but hold the tab on the connector
Caution
with your fingers.
Pulling by the wires too tightly can cause a
break.
7-41