Konica Minolta drypro 832 Service Manual page 125

This is the end of the process of removing the sub scan unit.
•
When replacing the right cover detection sensor, go to
12)".
•
When replacing the position regulation transport motor, go to
Motor (Page 7-19)".
•
When replacing the position regulation inlet sensor, go to
(Page 7-15)".
•
When replacing the Moderation belt, go to
•
When replacing the Transfer belt, go to
•
When replacing the Sub Scan transport motor, go to
•
When replacing the Sub Scan nip motor, go to
•
When replacing the Sub Scan inlet sensor, go to
•
When replacing the Sub Scan nip HP sensor, go to
•
When replacing the V-sync sensor, go to
Installation Procedure
Chapter 7 Replacing Sub Scan Unit Loading Parts
12
Pull out the sub scan unit toward you until it gets
caught and slightly lift it to remove.
•
When pulling out the sub scan unit, be
careful not to get it hung up on a wire.
Caution
•
The sub scan unit weighs approximately
16kg.
Carefully perform work when unloading
the sub scan unit from the main unit or
transporting it to work site.
•
If you place the removed sub scan unit on
a table, it may become extremely
unstable. If you apply excessive
pressure, it can overturn the unit.
"7.4 Replacing Right Cover Detection Sensor (Page 7-
"7.6 Replacing Position Regulation Transport
"7.5 Replacing Position Regulation Inlet Sensor
"7.7 Replacing Moderation belt (Page
"7.8 Replacing Transfer belt (Page
"7.9 Replacing Sub Scan Transport Motor (Page
"7.10 Replacing Sub Scan Nip Motor (Page
"7.11 Replacing Sub Scan Inlet Sensor (Page
"7.12 Replacing Sub Scan Nip HP Sensor (Page
"7.13 Replacing V-sync Sensor (Page
1
Install the sub scan unit.
•
Be careful not to get it hung on a wire.
•
The sub scan unit weighs approximately
Caution
16kg.
When putting the sub scan unit back to
the main unit, work should be performed
carefully.
2
Install the fixing screws of the sub scan unit.
• Four screws (M4×8)
7-23)".
7-25)".
7-27)".
7-30)".
7-34)".
7-38)".
7-40)".
7-7