Removing/Installing Pickup Unit Assembly - Konica Minolta drypro 832 Service Manual

4.2.2 Removing/Installing Pickup Unit Assembly

This section describes the procedure for removing or installing the pickup unit assembly when replacing the loading
parts in the pickup unit assembly.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing load parts.
Caution
Work outline
The number of personnel and the estimated work hours required to replace load parts is as follows:
Number of
Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
Removal Procedure
Work Hours
3 minutes each
Tools
1
2
3
Chapter 4 Replacing Supply Unit Loading Parts
No. Tools
2 Tray (container for screws and parts removed)
Pull the tray shutter out of the lower part of the
supply tray.
Insert the tray shutter into the slot in the upper
part of the supply tray with the tray shutter's UP
mark on the top surface toward you.
Inserting the tray shutter as far as it will go unlocks and
causes it to pop out several centimeters.
•
When replacing loading parts, be sure to
replace with the tray shutter attached.
Caution
If some of the film remains on the tray, the
film may be exposed.
•
Take sufficient care when handling the
tray shutter, as it may be impossible to
insert if it becomes deformed due to
rough handling.
•
If you feel any resistance when inserting
the tray shutter, stop the procedure and
refer to "17.1.7 Pickup malfunction
trouble (Page 17-6)"
Slowly pull out the supply tray fully.
Do not place objects on, lean on, or apply
loads on the pulled out supply tray.
Caution
to fix the problem.
4-11