Konica Minolta drypro 832 Service Manual page 488

Chapter 17 Troubleshooting
When the server PC is CS-2 or CS-3
START
Exit the DRYPRO 832
main unit
Server PC Installation
Adding Memory
Start the server PC
Exit the application
Install the Printlink Build
IN
Start the DRYPRO 832
Exit the application
17-100
Refer to "3.2.1 How to Exit" in the operation manual
Power source breaker OFF.
Refer to Printlink5-IN operation manual, and install server PC.
Refer to "7.3 Adding Memory" in the installation
If the power for the server PC is OFF, turn the power ON.
Connection error message is displayed when the server PC is CS-2 or CS-3.
Click the [Yes] button, and close the dialog box.
Caution
Refer to "7.4 Closing CS-2 or CS-3" in the installation manual
Refer to "7.5 Installing Printlink5-IN (Build IN)"
Select "Built IN" in the "Mode select" window at installation.
If the installation completes normally, the server PC will automatically restart.
Refer to "3.1.1 How to Start" in the operation
starts normally.
If the MEC upgrade is performed at startup, the startup time may take a few minutes
longer than normal.
Note
Refer to "7.4 Closing CS-2 or CS-3" in the installation manual
to exit the DRYPRO 832 and switch the
manual, and add memory.
to exit CS-2 or CS-3.
to install V1.02R00 or later Printlink Build IN.
manual, and check whether the DRYPRO 832
to exit CS-2 or CS-3.