Replacing Elevating Transport Nip Opening/Closing Motor - Konica Minolta drypro 832 Service Manual

6.4.2

Replacing Elevating Transport Nip Opening/Closing Motor

Replace the motor opens or closes the elevating transport nip.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing loading parts.
Caution
Work outline
The number of personnel and the estimated work hours required to replace loading parts is as follows:
Number of
Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3 Elevating transport nip opening/closing
motor (for replacement)
Chapter 6 Replacing Lispl-832 (Optional) Loading Parts
Work Hours
10 minutes
Tools
1
Install the elevating transportation unit with
reference to
in
Unit".
Caution
2
Remove the connector (JP79).
Caution
3
Remove the E ring with a precision screwdriver.
Caution
4
Remove the gears.
• Two gears
No. Tools
2 Tray (container for screws and parts removed)
4 Precision flat blade screwdriver
" Removal Procedure (Page 6-9)"
"6.4.1 Removing/Installing Elevating Transport
•
When removing loading parts, be sure to
replace with the tray shutter attached.
If some of the film remains on the tray, the
film may be exposed.
•
Take sufficient care when handling the
tray shutter, as it may be impossible to
insert if it becomes deformed due to
rough handling.
When removing the connector, do not pull by
the wires, but hold the tab on the connector
with your fingers.
Pulling by the wires too tightly can cause a
break.
When removing the E ring, be sure not to
exert too much force. Doing so may cause
you to stab your finger with the precision
screwdriver, or may cause the E ring to
spring out and become lost.
6-13