Konica Minolta drypro 832 Service Manual page 468

Chapter 17 Troubleshooting
Setting up Network
Set the serial number
Restore the setup
17-80
3. Select "Internet Protocol (TCP/IP)" from "This connection uses the following
items:", and click the [Properties] button.
"Internet Protocol (TCP/IP) Properties" dialog box is displayed.
4. Set the [Use the following IP address] radio button to ON and enter the factory
setting IP address and subnet mask.
5. Click the [OK] button and then the [Close] button.
Refer to "Setting Up Network" in "17.3.2 Replacing the Compact Flash (CF) (Page
setup the network.
1. Check the serial number in the label on DRYPRO 832.
2. Refer to "15.17 Product Setup (Page
DRYPRO 832.
Refer to "16.6 Restoring Settings (Page 16-26)"
15-37)", and set the Serial Number of
to restore the setup.
17-64)", and