Konica Minolta drypro 832 Service Manual page 459

Setting the Maintenance
Setup the maintenance schedule.
Schedule
If you do not have notes on the maintenance schedule (elapsed time, printed
(ELAPSED TIME,
sheets)
PRINTED SHEETS)
1. Calculate an appropriate value for the elapsed time and printed sheets from the
installation date, first scheduled maintenance date, and daily film output status for
the facility, refer to
values.
If you have notes on the maintenance schedule (elapsed time, printed sheets)
1. Refer to
and printed sheets values from your notes.
Caution
Enter the label of the Refer to
control BOX. Unit", re-enter the product setup items according to the label attached to the control BOX.
For PRODUCT SETUP, refer to
Set the image writing
Refer
position product setup items according to the label attached to the exposure unit.
For PRODUCT SETUP, refer to
Setting SIZE FINE Set each value for SIZE FINE TUNING.
TUNING (H) SIZE FINE
If you do not have notes on setting values
TUNING (V) SIZE FINE
1. Refer to
TUNING (Requested
the SIZE FINE TUNING (H) and SIZE FINE TUNING (V).
Size)
2. Refer to
(requested size).
If you have notes on setting values
1. Refer to
into SIZE FINE TUNING (H), SIZE FINE TUNING (V), and SIZE FINE TUNING
(requested size).
Set the correction Refer to
label attached to the control BOX.
Phase value
Sub phase value
Sub gain value
Offset value
Note
"15.14 Maintenance Schedule (Page
"15.14 Maintenance Schedule (Page
If the Lispl-832 is connected, set the Lispl-832 in the same way.
" Work after replacing the exposure unit (Page 8-5)"
"15.17 Product Setup (Page
to"14.2 Checking and Adjusting Image Data Writing Position (Page
"15.17 Product Setup (Page
"14.3 Checking and Fine Tuning the Print Size (Page
"15.17 Product Setup (Page 15-37)"
"15.17 Product Setup (Page 15-37)"
"14.1.1 Density Correction (Page
Gain value
There is no need to print here.
Chapter 17 Troubleshooting
15-31)", and set the
15-31)", and enter the elapsed time
in the "8.2 Replacing Exposure
15-37)".
14-13)", re-enter the
15-37)".
14-17)", and adjust
and adjust SIZE FINE TUNING
and enter the values from your notes
14-3)", re-enter the correction items according to the
Main Scan
OFFSET
position
adjustment
Sub Scan
OFFSET
position
adjustment
17-71