Adjusting Main Scan Offset (Lateral) Writing Position - Konica Minolta drypro 832 Service Manual

14.2.2 Adjusting Main Scan OFFSET (Lateral) Writing Position

If the difference between unexposed portions of the film on both sides exceeds 0.5mm, adjust the Main Scan
OFFSET (lateral) writing position.
1
Click the [PRODUCT SETUP] button under "SERVICE INFO.".
The "PRODUCT SETUP" window appears.
2
Enter the serial number of this product in "SERIAL NO.".
3
Enter the length of the unexposed portions measured in
(Page 14-13)" in the "HD OFFSET" entry field after calculating using the following formula.
4
Click the [SAVE] button.
5
Click the [BACK] button.
The "PRODUCT SETUP" window is closed. Then you will return to the Maintenance Menu window.
6
Perform "14.2.1 Checking Image Data Writing Position (Page 14-13)"
image writing position has been properly adjusted.
If it was not adjusted properly, perform
Position (Page 14-15)"
Caution
This is the end of the process of adjusting the Main Scan OFFSET (lateral) writing position.
"14.2.1 Checking Image Data Writing Position
If the unexposed portion A is longer:
Example: A = 2.0mm, B = 0.4mm
•
（B-A）/ 2 =（0.4 - 2.0）/ 2 = -0.8
Result: Enter a numeric value of HD OFFSET from which
"80" is subtracted.
If the unexposed portion A is shorter:
Example: A = 0.3mm, B = 1.5mm
•
（B-A）/ 2 =（1.5 - 0.3）/ 2 = 0.6
Result: Enter a numeric value of HD OFFSET to which "60"
is added.
"14.2.2 Adjusting Main Scan OFFSET (Lateral) Writing
again.
Chapter 14 Setting and Adjustment
again and check that the
14-15