Konica Minolta drypro 832 Service Manual page 233

Installation Procedure
3
Install the upper right cover, connector cover, film ejection tray, LAN cover, lower right cover,
and right cover with reference to
Installing Upper Right Cover".
This is the end of the process of installing the exterior of the operation panel.
Chapter 12 Replacing Loading Parts in the Exterior of Main Unit
1
Install the exterior of the operation panel.
• Two screws (M4×8)
2
Connect the connector (OCN1).
Be sure to push the connector all the way in
when connecting it.
Caution
If the connector is not connected properly,
an error will occur and, in some cases,
smoke and/or an odor may be generated.
" Installation Procedure (Page 3-15)"
4
Put the supply tray back into the main unit.
5
Remove the tray shutter and return it to the
previous position.
Take sufficient care when handling the tray
shutter, as it may be impossible to insert if it
Caution
becomes deformed due to rough handling.
in "3.3.3 Removing/
12-5