Konica Minolta drypro 832 Service Manual page 496

Chapter 17 Troubleshooting
Replacing MEC Board (V1.02 or Later)
This procedure is the replacing method when the software version of the DRYPRO 382 is V1.02 or later.
Refer to
Note
V1.01.
For information about the software version of the DRYPRO 832, refer to
25)".
Follow the procedure below to replace the MEC board.
Requirements
Prepare following when replacing MEC board.
No.
1 Replacement MEC board (V1.02 or later)
3 Backup file (DRYPRO 832)
5 DRYPRO 832 Installation Manual
START
Exit the DRYPRO 832
main unit
Replace the MEC board
Start the DRYPRO 832
Selecting replaced unit
Check the serial number
END
17-108
" Replacing MEC Board (Up to V1.01) (Page 17-106)"
Requirements
Refer to "3.2.1 How to Exit" in the operation manual
power source breaker OFF.
Refer to "11.3 Replacing Main Board (Page
Refer to "3.1.1 How to Start" in the operation
starts normally.
If the MEC upgrade is performed at startup, the startup time may take a few minutes
longer than normal.
Note
Following message is displayed in the operation panel of DRYPRO 832 when the DRYPRO 832
is started, then press the [Reset/Cancel] button.
•
"Which was changed? CF:enter MEC:reset"
If the [Open/Enter] button is pressed by mistake (selecting CF), or the "Which
was changed? CF: enter MEC: reset" message is not displayed, the actual film
Caution
count and set film count will differ, and a pickup malfunction will occur when
the film tray is empty.
Refer to "
and recover the previous status.
•
Pressing the [Reset/Cancel] button may cause MEC to start initialization. In that
case, above message is displayed after completion.
Note
•
Following message is displayed 3 minutes after above message is displayed.
•
"Turn OFF the power"
If the message is displayed, restart the DRYPRO 832 by pressing the operation
switch.
1. Check the serial number in the label on DRYPRO 832.
2. Refer to "15.17 Product Setup (Page
DRYPRO 832 is same.
if the software version is up to
"15.11 System Setup (Page 15-
No. Requirements
2 Upgrading file
(V1.02 or later)
4 DRYPRO 832 Operation Manual
6 DRYPRO 832 Repair Manual
to exit the DRYPRO 832 and switch the
11-7)", and replace the MEC board.
manual, and check whether the DRYPRO 832
When mistake was made selecting replaced unit (Page 17-109)"
15-37)", and check that the serial number of