Cleaning Control Box Intake Air Filter - Konica Minolta drypro 832 Service Manual

13.5 Cleaning Control Box Intake Air Filter

Clean the air intake filter in the control box.
Be sure to turn off power and remove the power cable from the electrical outlet before removing
or installing the exterior cover or replacing loading parts.
Caution
Work outline
The number of personnel and the estimated work hours required to replace loading parts is as follows:
Number of
Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3
Install the LAN cover with reference to
Removing/Installing Film Ejection
This is the end of the process of cleaning the control box air intake filter.
Chapter 13 Replacing and Cleaning Loading Parts on a Regular Basis
Work Hours
1 minute
Tools
1
2
"
Tray".
No.
2 Vacuum cleaner
Remove the LAN cover with reference to
Removal Procedure (Page 3-10)"
Removing/Installing Film Ejection
Take off the LAN cover and remove dust from the
outside of the air intake filter with a vacuum
cleaner.
Installation Procedure (Page 3-11)"
Tools
"
in "3.3.2
Tray".
in "3.3.2
13-13