Installing A Modular Raid Controller - Fujitsu PRIMERGY RX200 S6 Options Manual

9.2

Installing a modular RAID controller

A modular RAID controller can be installed in the server as an option.
Riser card #3 (see
Removing riser card holder with riser card #3
Ê Lift the required riser card holder with riser card #3 upward and remove it.
Installing a modular RAID controller
Ê Please read the documentation supplied with the modular RAID controller.
Ê Connect any required cables to the modular RAID controller.
Figure 31: Installing the modular RAID controller in riser card #3
Ê Carefully push the modular RAID controller into the slot of riser card #3.
I
Make sure that the modular RAID controller is positioned correctly
(see circle).
Installing the riser card holder with riser card #3
Ê Position the riser card holder over the relevant slot on the system board.
Ê Carefully push the riser card holder into the slot by pressing on the green
points.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
RX200 S6
figure 24 on page
Options Guide
Expansion cards and iBBU
56) is intended solely for this purpose.
73.
61