Ducati Monster 695 User Manual page 619

Immobilizer and Transponder
- ensure that countdown has started and turn the key to OFF before it reaches zero
remove the black key, insert the red key and set the switch to ON within the next 15 seconds (display
-
shows the number of keys inserted, in this instance 4, with the countdown from 30 to 0 at the side)
ensure that the countdown has begun and set the key to OFF before it reaches zero. The LED (1) on
-
the instrument panel will flash to indicate successful programming.
Now two black keys and the decoder inside the instrument panel are successfully programmed.
Continue as follows:
- turn the red key to ON within 15 seconds;
leave the key positioned to ON for 5 to 15 seconds (not less than 5 and not more than 15 seconds) to
-
allow data transfer from the decoder to the engine control unit and then turn the key to OFF
- allow 10 seconds before turning the key to ON again.
Now the programming procedure is over. Immobilizer programming is completed. The above
procedure must be fully complied with even though just a part of the immobilizer system needs to be
programmed. Partial programming is not allowed! When finished, ensure that the engine starts if
programmed black keys are used.
Warning
If "OFF" shows on the multifunction display when programming, it means that the programming
procedure has been aborted. Repeat the procedure from the start. Strictly comply with given times and
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_P_8_9_00.85.1.html (4 of 9) [10/7/2008 8:47:22 PM]