Thread - Ducati Monster 695 User Manual

Flywheel - generator
Check that starter clutch is installed correctly as follows. Remember that the flywheel is fitted to the crankshaft spline
and will turn with the crankshaft.
Turn the crankshaft counterclockwise. The flywheel will turn with the crankshaft, whereas starter motor and idle gear
will not move (same as when the engine is running).
Turn the crankshaft clockwise; flywheel, starter motor and idle gear will turn as well.
Caution
When refitting the parts of the starter clutch, use engine oil only. Do not use grease as it could affect starter clutch
operation.
Fit the flange (13) to the flywheel (16) with the tapered side facing the flywheel.
Install the flange with the aid of a pin or spanner fitted into the hole for the rotor flywheel reference pin (14) so to
line up the flange threads with the flywheel holes. Since the flange is an interference fit, alignment must be done
during - not after - installation.
Position reference pin (14) with circlip (15) into flywheel.
Apply threadlocker on the threads of screws (25) and fix rotor (23), flange (13) and starter clutch (21) to flywheel
(16).
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_8_9_00.72.1.html (8 of 14) [10/7/2008 8:46:19 PM]