Ducati Monster 695 User Manual page 232

Steering
Caution
Do not refit oil seals (4) and (7) and bearings (5) and (6) once they have been removed. Always fit new components.
Using a drift, remove the outer bearing rings (C) from the steering tube. Proceed with care. Do not damage the ring
seats.
Refitting the steering tube components
Caution
Steering bearings (5) and (6) are identical, however, never mix their components.
Clean all contact surfaces and grease with the recommended grease.
Use the tool no. 88713.1062 to fit the outer rings (C) of bearings (5) and (6) onto the headstock. Proceed as follows:
heat steering tube up to 150 °C;
place the outer rings (C) of the bearings into the seats in the steering tube;
insert the fixed bush (E, with threaded bore) of the tool into the bottom ring;
fit the other bush (F, moving bush) into the upper end of the tool rod and push it against upper bearing ring;
screw nut (G) and use the wrench to push the outer rings (C) against steering tube;
leave tool assembled to steering tube until the latter has cooled down to ensure that bearings become fully seated in
their seats.
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_H_2_7_00.42.1.html (5 of 8) [10/7/2008 8:44:15 PM]