Ducati Monster 695 User Manual page 537

Casing unit: connecting rods
Changing the connecting rod small end bush
Replace small end bush (6) using the tool shown in the figure. This tool lets you extract the worn bush and install a
new bush (A) at the same time.
Locate the new bush to the small end of the connecting rod with the opening at right angles to the upper hole of the
con-rod small end.
Drill the new bush at the same positions of the oil holes of con-rod small end.
Bore out bush until obtaining a bore diameter (D) of 18.006-18.024 mm.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9C9_00.75.1.html (4 of 10) [10/7/2008 8:46:40 PM]