Clutch hydraulic control
Tighten the retaining screws (7) to the specified torque (Sect. C 3,
sequence.
Position the pipe (6) onto the clutch cylinder assembly (1) with a seal (8) and secure with special screw (9). Do not
tighten it yet.
Warning
Incorrectly positioned hoses can cause faults and interfere with moving parts.
Refer to the figures at the end of these section for the correct routing of the clutch hose (6) and hose ties.
Position the hose (6) as shown in the figure and then tighten the special screw (9) to the specified torque (Sect. C 3,
Frame torque
settings).
Operations
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_F_2_6_00.26.1.html (3 of 8) [10/7/2008 8:43:23 PM]
Reference See Section
Frame torque
settings) working in a 1-2-1