Table of Contents
Advertisement
Fuel injection-ignition system components
To refit, tighten the sensor to the specified torque (Sect. C 3,
Air temperature / pressure sensor
This sensor is powered by the electronic unit. It supplies information about the absolute air pressure in
a neutral area of the motorbike and measures temperature. The sensor sends electronic signals to the
control unit for correction in accordance with the temperature and barometric pressure.
Note
To check operation of this component, use the DDS, follow instructions given under
diagnosis" (Sect. D 5).
Removing the air temperature / pressure sensor
To gain access to the air temperature/pressure sensor (1), remove the headlight (Sect. P 4,
the
headlight), disconnect the main wiring harness connector (3) at sensor end, unscrew the sensor
retaining screw (2) and release the screw from the front subframe.
Refitting the air temperature / pressure sensor
Reverse the removal procedure and tighten the sensor retaining screw (2) to the specified torque
(Sect. C 3,
Frame torque
After refitting, reconnect the connector (3) to the sensor.
Refit the headlight (Sect. P 4,
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_M_3_3_00.57.1.html (8 of 15) [10/7/2008 8:45:06 PM]
settings).
Changing the
headlight).
Frame torque
settings).
"Guided
Changing
Hide quick links:
Advertisement
Table of Contents
