Table of Contents
Advertisement
Flywheel - generator
Clean off any deposits and degrease the mating surfaces of the LH-side casing and the generator cover.
Fit the two reference bushes (29).
Apply an even bead of DUCATI liquid gasket on the cover surface (28), avoiding the holes for the retaining screws
and the centring bushes.
Grease the end of the crankshaft and of the gear change lever shaft. This will facilitate cover installation and prevent
damage to the oil seal (3) if it is already installed in the cover.
Tap at different positions with a rubber mallet to help locate cover to shafts and centring bushes.
Note
In the event you need to remove the cover again, fit puller part no. 88713.1749 to the threaded holes at the
crankshaft.
Start the retaining screws into their holes as indicated in the table.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_8_9_00.72.1.html (11 of 14) [10/7/2008 8:46:19 PM]
Hide quick links:
Advertisement
Table of Contents
