Ducati Monster 695 User Manual page 220

Final drive
Slacken the chain
Remove the rear wheel
Slide the complete rear sprocket flange (2) off the rear wheel.
Hold the pins (1) at the rubber cush pads steady and undo the nuts (6) retaining the sprocket to the flange.
Caution
The pins (1) have left-hand threads.
Remove the rear sprocket.
Refitting the rear sprocket
Make sure that all pins (1) are securely in place in the flange (2). If not so, unscrew the left-threaded pins, clean
the threads and apply threadlocker to the thread with the larger diameter.
Tighten them to the flange to the specified torque (Sect. C 3,
Apply threadlocker to end threads of the pins (1).
Fit the new sprocket (5), hold the pins and tighten the nuts (6) to the specified torque (Sect. C 3,
settings).
Warning
Perform the procedure carefully. If any one pin is not tightened securely fully home into the flange before the nuts
are tightened on the sprocket, the sprocket will be installed incorrectly, endangering rider and motorcycle safety.
Grease pins (1) and fit the rear sprocket flange (2) in the rear wheel hub, fit the pins in the relevant rear wheel cush
drive rubbers (G).
Install the spacer (8) with the tapered end facing the rear sprocket flange.
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_G_8_8_00.39.1.html (5 of 6) [10/7/2008 8:44:07 PM]
D 4, Adjusting chain tension
G 4, Removing the rear wheel
Frame torque settings).
Frame torque