Casing unit: connecting rods
Use a dial gauge to measure the alignment of main bearings with the crankshaft placed between two centres (Sect. C
1.1,
Cylinder /
piston).
Undo all crankshaft plugs (4), (3) and (2). If they are hard to remove, heat plug to remove the threadlocker used at
assembly.
Use an air gun capable of reaching 150°C.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9C9_00.75.1.html (6 of 10) [10/7/2008 8:46:40 PM]