Ducati Monster 695 User Manual page 196

Rear wheel
Refitting the rear wheel
Fit the rear sprocket flange onto the wheel (Sect. G 8,
If the slider (16) has been removed, fit it into the swingarm together with the cover (15) and start the screws (4) in
their holes. Fit the first plate (3) to the shaft (2). Grease the wheel shaft thread (2) and the contact surface of the nut
(1). Snug the nut on the wheel shaft thread (2). Tighten the nut until one circle of the wheel shaft thread is visible at
the opposite end.
Insert the wheel shaft from the left end of swingarm. Make sure to match the hole in the left chain slider.
Hold the caliper plate in position onto swingarm clip, fit the clip into plate slot.
Slide the wheel in the swingarm.
Insert the wheel shaft (2) from the left side of the swingarm through wheel hub, brake caliper plate hole and right
chain slider hole and push the wheel shaft fully home.
Make sure the plate bent end (3) is at the bottom end of the swingarm.
Wrap the chain around the rear sprocket.
Fit the other plate (3) on swingarm right-hand side.
Grease the wheel shaft thread (2) and the contact surface of the nut (1) and screw nut onto shaft (2).
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_G_4_8_00.35.1.html (4 of 5) [10/7/2008 8:43:53 PM]
Refitting the rear sprocket).