Ducati Monster 695 User Manual page 513

Casing unit: crankcases
Remove timing layshaft (2).
Collect O-Ring (5) in the oil duct between casings.
Overhauling the casings
Carefully inspect the crankcases.
Place the casings on a reference surface and check that the mating surfaces of the casings are perfectly flat. Check
bearings (4) and (23) for wear. Note that the main bearings must always be changed in pairs (see procedure in "Main
bearings", next paragraph). If you have to change the gearbox primary shaft bearing (12), remember that there is a
seal (13) placed between bearing and chain-side casing.
Note
It is a good rule to change all casing bearings every time an engine is overhauled.
When replacing gearbox shafts bearings (14) and (10), secure them in place in the casings using the spacers (17)
and the stop plate (9).
Change the oil seal (11) placed outside the bearing (10) every time casings are overhauled.
file:///C|/Documents%20and%20Settings/F4i/My...anual/wsm/usa/Mon695_MY07_N_9B9_00.74.1.html (5 of 25) [10/7/2008 8:46:34 PM]