Table of Contents
Advertisement
Rear brake
Tighten the special screws (1) to the specified torque (Sect. C 3,
to the swingarm and secure the retainer (12) with the screw (16).
Fit the rear brake caliper (3) to the brake disc matching the holes in the caliper plate. Grease the thread and
underhead of the screws (5). Slide the washers (7) and the spring washers (6) on the screws (5). Tighten the screws
(5) to the specified torque (Sect. C 3,
Note
The air gap between sensor (13) and brake disc retaining screw (14) must be 0.6-2.2 mm.
Operations
Tighten the screw retaining the hose
to the rear brake master cylinder
Fill the rear braking system
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_G_6_8_00.37.1.html (4 of 4) [10/7/2008 8:44:00 PM]
Frame torque
settings).
Reference See Section
F 4,
Refitting the rear brake master
cylinder
D 4,
Draining the braking circuit
Frame torque
settings). Position the brake hose (A)
Hide quick links:
Advertisement
Table of Contents
