Ducati Monster 695 User Manual page 144

Clutch hydraulic control
Fill the clutch circuit
Removing the clutch transmission unit
Warning
Critical safety components. The clutch transmission unit manufacturer recommends that you do not attempt to
service the internal components of the clutch transmission unit (14).
Incorrect overhaul of these critical safety components can endanger rider and passenger safety.
Only a limited number of transmission unit parts should be replaced, that is bleed unit, seal and complete piston.
Operations
Drain the clutch circuit
Unscrew the 3 screws (15) fixing the clutch transmission unit (14) to the engine.
Withdraw the unit from the casing. Be careful of the O-ring (13) placed inside.
Remove the dust seal (12) and the bleed unit (11), loosen the screw (10) and then collect the seals (8): the unit (14)
is now released from hose (6).
Push in the piston to expel all fluid inside the unit.
The clutch pushrod (16) can now be removed. Check the two O-rings (17) for wear and replace, if necessary.
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_F_2_6_00.26.1.html (4 of 8) [10/7/2008 8:43:23 PM]
D 4, Filling the clutch circuit
Reference See Section
D 4, Draining the clutch circuit